question about somes car attributes

Discuss or share your car-related work here

Moderator: kilo

Re: question about somes car attributes

Postby mikado » Sat Feb 21, 2015 5:12 pm

Have you seen the following tutorial?
Yes, it is intended for TORCS, but still most vehicle physics parameters are the same in SpeedDreams.

I think the option "packers" describes the length of the suspension when it is totally compressed, i.e. the minimum length possible for the suspension.
Posts: 5
Joined: Fri Jan 30, 2015 7:16 pm

Re: question about somes car attributes

Postby nonobecane » Sat Feb 21, 2015 6:13 pm

Thank you mikado,

Ok for packers but in the video roll center height it's not explain and for bellcranck my english is too poor for understand the explain.

For bellcrank I think It's like the rear suspension of a motorbike and the value is a ratioImage
(source of the image

For roll center height, I don't know where is the 0 in SD2?
0 is the ground or 0 is the wheel axle ?Image
source of the image
Image SD2 svn / Debian Sid 64 / 1920x1080 on GTX580 / Logitech G25
Posts: 29
Joined: Sat Jan 04, 2014 10:20 am
Location: France


Return to SD Cars

Who is online

Users browsing this forum: No registered users and 3 guests