DIY 'H-pattern' shifter

For random discussions which aren't directly related to Speed-Dreams

Moderator: kilo

DIY 'H-pattern' shifter

Postby mungewell » Wed Jan 01, 2014 3:16 am

I saw this posting a few weeks ago on Hack-a-day:
http://forums.hackaday.com/viewtopic.php?f=3&t=327

This afternoon I attempted something similar, with a few adjustments. I cut the head off the 6inch 3/8ths bolt so that a shifter knob could be installed directly, and instead of the spring I just used a short piece of 5/8ths fuel line with a bolt fixing it to the bottom of the box.
Image
Image
Image

Next to get a cheap chopping board to make the 'H' pattern and a 2nd hand game controller to wire it up...
Simon
mungewell
 
Posts: 307
Joined: Fri May 20, 2011 4:05 pm
Location: Southen Alberta, Canada

Re: DIY 'H-pattern' shifter

Postby mungewell » Sat Jan 18, 2014 10:56 pm

Picked up a cheap $5 cutting board and went to work.
http://www.flickr.com/photos/24244464@N03/sets/72157639908739075/

And the result looks like this.
Image

General thoughts are that the gates are a little too wide (so will have to make closer on the next one), but apart from that it shifts OK. When you drill/cut the outer gates (gears 1,2,5 & 6) remember that the shaft will be angled, a keep checking against you base that the shaft has enough travel to lock into gear.

Next is to find an old game pad to rip apart...
mungewell
 
Posts: 307
Joined: Fri May 20, 2011 4:05 pm
Location: Southen Alberta, Canada

Re: DIY 'H-pattern' shifter

Postby chad3006 » Wed Jan 22, 2014 2:46 pm

Cool. Are you going to put some kind of switches in it to indicate (to the game) which gear you're in?
User avatar
chad3006
 
Posts: 231
Joined: Mon Aug 13, 2012 7:56 pm
Location: USA

Re: DIY 'H-pattern' shifter

Postby mungewell » Wed Jan 22, 2014 4:20 pm

Yep, the idea is to rip apart an old gamepdad and use that for the USB side of things. A better, more professional approach would be to use an Ardunio/Teensy/etc to do a custom HID device.... but I'm just mucking around at the moment.

Probably will just use paperclips to short across the steel shaft, micro-switches would be nicer but I fear there's not enough space for mounting them for 3rd and 4th gear.

You will see from the pictures that I have cut extra bits to make up a second device when I've mastered it.
Simon
mungewell
 
Posts: 307
Joined: Fri May 20, 2011 4:05 pm
Location: Southen Alberta, Canada


Return to Off-topic

Who is online

Users browsing this forum: No registered users and 3 guests

cron