Its strange though because if you look at the track in Track Editor and zoom in really close to the start/finish line, you can see that's it's not lined up, but it's almost perfectly lined up in the game. Its really odd. O_o.
But that's the only way I could get the seam to line up in the game. It just doesn't make any since. I'm confused about that.
I'll try your method on my next track if I have any issues. The track that I had that issue with is my HiSpeed track, which I've already uploaded.
Statistics: Posted by Snake — Mon May 18, 2015 6:31 pm
]]>
trackgen outputs delta x, delta y, delta z and delta angle.
delta z is obvious (use the same z start for the first as z end for the last segment)
if delta angle is anything else than zero, adjust one arc by this amount to sum up to 360 degrees overall turn angle
adjust delta y: if you have any segment that is exactly perpendicular to start lane, simply change the length of this one by delta y; otherwise use another straight segment and change the length by 1/cos(angle)*deltaY (angle being the angle between start lane and this segment)
now, delta y should be zero and you can adjust delta x by the length of start lane segment
and you're done
Statistics: Posted by simon-2 — Mon May 18, 2015 1:03 pm
]]>
I started getting a small headache last night while I was trying to fix it.
Statistics: Posted by Snake — Thu May 14, 2015 6:13 pm
]]>
]]>
]]>
]]>
I'm having a bit of an issue at the start/finish line. I cannot seem to get the seam to line up and I've been wrecking my brain trying to figure it out. I've already tried messing with the arch for each turn to no avail. But it's also possible that I just didn't get the arch just right yet but I just don't know. I'm hoping someone here can shed some light as to what I need to do.
I've posted a image below of the problem. It starts there and goes all the way to one of the pit buildings.
Thanks.
torcs-unlined.jpg
If anyone wants to look at the track in the Track Editor I can upload it.
Statistics: Posted by Snake — Wed May 13, 2015 7:55 pm
]]>